Boat Docking Lines
Boat Docking Lines
NAUTICAL KNOW-HOW: The Lowdown on Lines
It’s fall, and you’re getting ready for last-chance autumn cruising. In looking over your boat’s gear, you notice that your dock lines are showing signs of chafe. Not wanting to take any chances, you head to the local chandlery, where you are met with a wall full of rope. What should you know? The information on available options could fill a dissertation, but the following should help you get started.
Materials
There was a time when all line was made of cotton or hemp. The problem was that these materials stretched over time, absorbed water and disinte-grated in sunlight. For years boaters combated these prob-lems by coating lines with tar. Then in 1935 a DuPont scientist named Wallace Hume Carothers developed nylon, which brought about a revolution in the industry. Suddenly there was a fiber that was not only stronger, but would not rot, was more resistant to chemicals and didn’t disintegrate in the sun. Nylon’s drawback was that it melted at relatively low temperatures, so Carothers and his team kept working, eventually developing Dacron (polyethylene terephthalate) in 1941. Since that time the number of synthetics used in ropes has mushroomed, with stronger, higher-tensile materials coming along, including polypropylene, polyesters, high-modulus polyethylene (Dyneema and Spectra), liquid crystal polymer (Vectran), aramids (Twaron and Technora) and PBO (Zylon).
For most recreational uses, nylon and polyester work fine. Nylon is strong, with excellent energy absorption and good UV resistance. It is best for dock lines, anchor rodes and other applications where it must absorb dynamic shock loads. It should be noted, however, that nylon loses some tensile strength when wet. Polyester is also strong and UV-resistant, with better abrasion resistance and less water absorption, but with lower stretch than nylon. In general, polyester is best for running-rigging applications and for lines that primarily handle static loads.
The more exotic materials are mostly used on high-end racing sailboats. They can be very strong, reduce weight aloft and have very little stretch, but they are commensurately expensive. High-modulus polyethylene (HMPE) is stronger and lasts longer than polyester or nylon; it also floats. It is best for high-load applications. Liquid crystal polymer withstands high temperatures, but more importantly for sailors, does not creep, even under very high loads. Aramids have the highest heat resistance and are best for lower load, low-creep applications. Finally, PBO has the highest strength and lowest stretch of any commercially available fiber, but it does not do terribly well in water or sun. This fiber is now used instead of wire or rod for standing rigging in applications where light weight aloft is essential. However, it must be very well protected, either by a coating or a cover.
Polypropylene is light and floats, but it is not terribly strong and, if left untreated, has poor UV resistance. It’s usually used where high strength is not necessary, for example, to mark swim areas or as a cover fiber where it’s abrasiveness gives it a good hand.
In fact, many ropes are made of a combination of fibers—often a low-stretch core will be surrounded by a more-durable protective cover.
Construction
Rope manufacturers are tasked with making fibers into rope. The fibers are extruded and spun into yarns in different directions (S equals clockwise and Z equals counterclockwise twists), then put on spools. This allows the twist of the yarn to align with the twist or braid of the rope. Twisted fibers aligned with the longitudinal direction of the rope will maximize abrasion resistance and tensile strength. The spools are then placed on machines, which wind the strands onto bobbins for rope laying or braiding—all while maintaining uniform strand tension.
In three-strand twisted rope the yarns are wound into strands of varying thickness. These strands are then wound around each other. The direction of this twist is called the lay of the rope. Right-laid is twisted clockwise, and left-laid is twisted counterclockwise. This is the loosest construction method and therefore has the greatest stretch and is the easiest to splice. It is available in soft, medium and hard lay, based on how tightly wound it is. A hard-lay three-strand is best for mooring lines, because it better resists untwisting. Looser lays are better for anchor and dock lines, because they can better absorb shock loads. Twisted rope is less expensive, because it runs much more quickly through the manufacturing process than braids. The drawbacks are that it may not have a great hand, runs less well through blocks and is subject to torque.
The other option is to braid the rope. In this process, the bobbins carrying the yarns weave around each other as on a maypole, creating a braid. This rope generally has less stretch, a better hand, runs better through blocks and is stronger per pound of fiber. Chafe sleeves or coatings may be required to prevent snagging on dock pilings. Braids are also more difficult to splice.
There are several different types of braided rope. The simplest is single-braid, where one set of twisted strands is braided into a hollow construction. Single-braids tend to be most flexible and have a good hand. New England Ropes’ Regatta Braid, a popular sheet line, is an example of a 12-strand single-braid. A single-braid core can have a cover braided over it, creating a double-braid, which is probably the most popular construction among recreational boaters. Double-braids tend to be somewhat stiffer, resist flattening and are pleasant to hold. The cover protects the core, making it stronger and more durable.
Another type of line, parallel-core construction, is predicated on the fact that no matter what the fiber, bending it reduces its strength. The core yarns are kept straight or slightly twisted then a cover is braided around them. These constructions often have a very stiff feel and can be difficult to splice.
Paraloc uses a relatively new patented process that braids the cover and the core yarns together, creating a rope that has very little stretch or creep and runs well through blocks and stoppers. However, it is expensive, stiffer than traditional constructions and difficult to splice neatly.
Finishing Techniques
Some manufacturers pre-stretch their ropes to minimize stretch and creep under load. Others, like New England Ropes, use heat and pressure to relax the fibers, making them more flexible and less likely to stretch.
Novatec uses UV-stabilized marine-finished polyester and nylon yarns to improve the rope’s wet abrasion resistance. For colored ropes, only solution-dyed yarns should be used. Urethane coatings can also be applied to increase abrasion resistance and minimize water absorption.
A Word About Diameters
Even before you decide on material and braid, it is a good idea to know what diameter line you are looking for. For some applications this is easy: Choose the diameter that best fits the smallest block through which the line will be running. For others there is more leeway. Dock lines, for example, need to be thick enough that they will hold your boat in a blow and are easy to throw and catch. But they should not be so thick that they don’t fit securely on your boat’s cleats.
Maintenance
A few simple things will greatly extend the usefulness of your lines. First, it is a good idea to occasionally rinse all lines with fresh water. Avoid using detergents, as they could damage the fiber’s protective coatings. Second, try to store them, coiled neatly, where they will be exposed to air, but protected from sunlight, water and chemicals.
Back to the Dock-Line Question
Based on the information above, you’re looking for a relatively inexpensive line made from solution-dyed, UV-stabilized and marine-finished yarns. It should have high energy absorption (recoverable stretch), sufficient tensile strength and twist-aligned cover strands. Nylon three-strand and double braid are the best options for this application. Three-strand is less expensive, has high stretch and, with a medium lay, may be more chafe- and snag-resistant. Double-braid is stronger, more UV-resistant, easier to handle and comes in a variety of colors. Cut the right length, put an eye splice in at least one end and you’re ready for the rest of the season—and many more.
About the Author
By Gaelen Adam, contributing writer for Chesapeake Bay Magazine. For more great articles and photos on boating, sailing, fishing, and cruising, visit http://www.ChesapeakeBoating.net
Can someone give me info on Bahamas cruising?
We are taking our first cruise to the Bahamas on Norweigian cruise line, and will be getting married in Grand Bahamas Island. I’m hearing that the cruise ships have their own personal islands, where they dock, but we will need to go off the island and into the city to marry at the Justice of the peace. Does anyone know how far the City Registrars office at the Fidelity Financial center is from where the boat docks and how we can get there and the approx cost of a cab ride. Please if you can help…I’m a frantic bride to be!!! Thank you so much
Here is some information that may be helpful to you.
The Register’s Offices on the various islands. In Freeport, Grand Bahama Island you may reach them at The Assistant Registrar General of The Bahamas, P.O. Box F-42602, Freeport, Grand Bahamas, Bahamas.
Telephone 242-352-4934/7 or Fax 242-352-4060.2.
Bahamas Law states that the couple must be resident in The Bahamas for 24 hours prior to the date of the application. A Bahamian-issued marriage license is valid for 90 days for those seeking early application. You can write the Registrar General prior to your arrival at: P.O. Box H-5553, Nassau , Bahamas , or fax to 242-322-5553. If either party is a minor (a person under 18 years of age), parental consent is required. Forms of consent may be obtained from the Registrar General’s office
Here is a link with requirements.
http://www.bahamasbeachweddings.net/requirements.html
Good Luck, I would call the Registrars office with all of your questions)
How to braid dock line into a neat bundle
|
|
iHome iP43LVC Dual Alarm Clock Radio for your iPod/iPhone with Pillow Shaker (Blue) $75.95 Sla 12v 18ahupg 85977/d5745 sealed lead acid batteries (12v; 18 ah; ub12180). Specs: used in ups backup systems, spotlights, flashlights, exit lighting & other equipment; 12v; 18 ah; ub12180. Refurb: n. Returnable: y. Warranty: one year……. |
|
|
Dual Alrm Clck Rad Iphone/ipod Purple Charge Play Or Wake $91.77 iHome IP43UV Desktop Clock Radio IP43UV Clocks… |
|
|
Alex Super Baking set – 18 Piece Metal and Plastic Set $16.99 Measure, mix, prep, and bake some imaginary treats| This 18-piece set features a loaf pan, bear pan, heart pan, mixing bowl, rolling pin, whisk, measuring spoons and cup, pastry wheel, 2 star cookie cutters, 2 heart cookie cutter, and an oven mitt. Bon Appetit|… |
|
|
Passion of the Christ: Songs (Original Songs Inspired by the Film) $7.00 … |
|
|
Egyptian Hieroglyphs Made Easy $26.50 Learning and understanding of the ancient Egyptian hieroglyphic language. The hieroglyphic script was the longest lived and earliest form of the Egyptian language. Its use was limited primarily to religious and monumental inscriptions, whereas a more cursive script called hieratic was preferred for administrative and epistolary purposes. Hieroglyphic Egyptian employs pictures of objects, each with… |
|
|
Promised Land [CD-ROM] Queensryche’s follow-up to the double-platinum Empire is something of an acquired taste, but it’s well worth the effort. There’s considerable variety here; the heavy progressive-rock of “I Am I” and the ballad “Bridge” were hit singles, but there’s also the funk-inflected “Disconnected”, the edgy, spooky “Lady Jane”, and the piano-and-vocals “Someone Else?”. The title track is probably the stronge… |
|
|
Modern Floral Bird – Vinyl Wall Decals Murals Stickers Art Graphic – 46H x29W – by üBer Decals Better than wallpaper, wall stickers are a perfect way to decorate your room and express yourself. They are a fun, easy and removable decor solution. These stickers are pre-cut and will only take you several minutes to apply on any surface – walls, doors, windows, and more. Each of our designs come with easy instructions to follow. This is an original design from uBer Decals. All other sellers are… |
|
|
Yoga Girl – Vinyl Wall Decals Murals Stickers Art Graphic – 25H x 35W – by üBer Decals Better than wallpaper, wall stickers are a perfect way to decorate your room and express yourself. They are a fun, easy and removable decor solution. These stickers are pre-cut and will only take you several minutes to apply on any surface – walls, doors, windows, and more. Each of our designs come with easy instructions to follow. This is an original design from uBer Decals. All other sellers are… |
|
|
2.5mm Hands-Free EarBud Headset + Car Kit Vehicle Plug in Adapter + Home Travel Wall Charger for ATT Nokia Mural Grouper 6750 Cell Phone $5.99 Brand new premium quality MP3 Earbud and hands-free headset for your cell / smart / PDA phone. Acoustically tuned speaker for improved sound clarity even in noisy environments. Soft covered ergonomic earpiece for comfort even over extended periods. **Phone & Ear bud features are limited to the phone’s capability and the service provider’s default settings. Please consult with your phone’s user man… |
|
|
Shawn Interrupted $1.99 … |
